Hotchkis 4002 1993-2002 Camaro-Firebird Sub Frame Connector Uživatelský manuál stáhnout pdf

#4002 SUBFRAME CONNECTORS 1993-2002 CAMARO/FIREBIRD

Please read instructions completely before starting installation. Hotchkis

Performance subframe connectors are weld-in units and may require modification

of the exhaust system. This installation should be performed by a welding

professional only! They can not be installed on convertibles.

1) Support car securely on jack stands or hoist. Leave area under doors clear for

placement of subframe connectors. Begin on the passenger side.

2) Attach the rear of the connector to the trailing arm mount using existing hardware,

and then lift until the front contacts the floor of the car. Use a marker to show where

the front of the connector contacts the floor. With connector held in place, mark the

trailing arm mount around the outside of the connector flange and as far as possible

along the bottom of the flange.

3) Remove the connector and grind the areas marked on the car for welding. Be sure to

grind through all protective plating.

Grind powder coating off of the subframe

connectors in areas to be welded.

4) Put the subframe connector in place and tighten the trailing arm bolt to a snug fit.

Tack weld the connector in several places at each end. Remove the rear control arm

and completely weld in the subframe connectors. When the area has cooled, paint

welds and any bare metal.

5) Install control arm and torque to 70 ft./lbs.

6) Proceed to driver’s side. Repeat steps 2 through 5. To correctly position front of

connector, remove the plastic clip holding hard lines to the floor bracing. Leaving the

black plastic fuel lines in place, pull the hard lines down far enough to slide the front

mount of the connector between the hard lines and the floor brace. Be sure to protect

all lines during welding.

7) Drill a hole in the floor brace to reposition the plastic clip for the hard lines. When all

weld areas have cooled paint welds and any bare metal.

1 2 3 4

Strany 1

#4002 SUBFRAME CONNECTORS 1993-2002 CAMARO/FIREBIRD Please read instructions completely before starting installation. Hotchkis Performance subframe

Hotchkis Performance LLC Return Policy & Limited Warranty Effective December 1, 2010 all Hotchkis products must be registered to qualify for wa

 Improperly installed or installed by someone other than a qualified, licensed auto mechanic experienced in the installation and removal of suspensi

 Did you register the product at www.hotchkis.net or via the mail-in warranty card within 30 days of purchase?  Is the product appropriate to your

Žádné komentáře

Hotchkis 4002 1993-2002 Camaro-Firebird Sub Frame Connector Uživatelský manuál